Linkstation pro install without telnet access

[rothgar]

I have been trying to get Twonky 4.4 installed on my Linkstation for a little while now. It worked without a problem when I had the stock firmware (using telnet to install it) but now I upgraded to the freelink firmware and I cannot get telnet to start again. Is there a way to install Twonky 4.4 on a linkstation without needing telnet? I tried just dragging all the files over but I got this error.
./twonkymedia: /lib/libpthread.so.0: version `GLIBC_2.4' not found (required by ./twonkymedia)
./twonkymedia: /lib/libc.so.6: version `GLIBC_2.4' not found (required by ./twonkymedia)

What files are required to run twonkey on a Linkstation? or is there another installer besides the telnet installer?

Thanks

[rothgar]

Is there no manual install for this software?
Does anyone at least know what files are needed for installation and where they are located?

[whitecloud1]

Have you given up on this or do you still want advice. I have Twonky installed on LsPro using Freelink. I also have it on Windows.

JB

[asudman]

whitecloud, I just purchased a linkstation pro duo and would greatly appreciate it if you would float any advice that you have.

thanks!