Twonky Forum

I have been trying to get Twonky 4.4 installed on my Linkstation for a little while now. It worked without a problem when I had the stock firmware (using telnet to install it) but now I upgraded to the freelink firmware and I cannot get telnet to start again. Is there a way to install Twonky 4.4 on a linkstation without needing telnet? I tried just dragging all the files over but I got this error.
./twonkymedia: /lib/libpthread.so.0: version `GLIBC_2.4' not found (required by ./twonkymedia)
./twonkymedia: /lib/libc.so.6: version `GLIBC_2.4' not found (required by ./twonkymedia)

What files are required to run twonkey on a Linkstation? or is there another installer besides the telnet installer?

Thanks

Is there no manual install for this software?
Does anyone at least know what files are needed for installation and where they are located?

Have you given up on this or do you still want advice. I have Twonky installed on LsPro using Freelink. I also have it on Windows.

JB

whitecloud, I just purchased a linkstation pro duo and would greatly appreciate it if you would float any advice that you have.

thanks!