Twonky Forum

I am trying to install 4.4.18 on DNS-323. I used ffp to open up telnet then installed 4.4.18. The installation went smooth. However, I can't get to the <IP>:9000 or <IP>:9000/config.

The browser keeps saying Opening page at the bottom. I see the twonkyserver is running.

Any idea?

I tried rebooting the DNS-323 and the config page was working and it stopped working again. I have tried rebooting DNS-323 a few times but it didn't help this time.

I have already reset the DNS-323 to factory settings. It has a single 1TB running firmware 1.06.