TwonkyServer "freezes" on Synology DS 210j ...
Posted: Wed Jun 22, 2011 1:24 pm
Hi there!
I'm observing the following problem ...
I installed and tried all versions of TwonkyServer 6.x available as Kirkwood build. The outcome is always the same:
The server starts off very nicely scanning the respective directories on my NAS and being also fairly responsive to clients (e.g. iPhone app). Then, at approx. 16 MB cache size it gets slower and slower until it freezes completely.
The strange part is, that the two disks of my NAS are still extremeley active, when this happens!
I tried all kinds of settings according to recommendations found in this forum (e.g. nmcmode) and even created an additional 1GB of swap memory following a recommendation from the Synology technical support ... none of them solved the problem ...
As I am a registered user of TwonkyServer and really would like to continue using Twonky I'd be grateful for hints or maybe even a solution for this!
My setup:
- Synology Disk Station DS 210j, DSM v3.1-1742 (latest version)
- no 3rd party packages installed (except Twonky)
- TwonkyServer (tried versions 6.0, 6.0.1, 6.0.23, 6.0.30, 6.0.31-RC6, 6.0.32)
Any ideas???
Thanks a lot in advance!
Jeeosch
For info: I posted the same issue in the Synology forums.
I'm observing the following problem ...
I installed and tried all versions of TwonkyServer 6.x available as Kirkwood build. The outcome is always the same:
The server starts off very nicely scanning the respective directories on my NAS and being also fairly responsive to clients (e.g. iPhone app). Then, at approx. 16 MB cache size it gets slower and slower until it freezes completely.
The strange part is, that the two disks of my NAS are still extremeley active, when this happens!
I tried all kinds of settings according to recommendations found in this forum (e.g. nmcmode) and even created an additional 1GB of swap memory following a recommendation from the Synology technical support ... none of them solved the problem ...

As I am a registered user of TwonkyServer and really would like to continue using Twonky I'd be grateful for hints or maybe even a solution for this!
My setup:
- Synology Disk Station DS 210j, DSM v3.1-1742 (latest version)
- no 3rd party packages installed (except Twonky)
- TwonkyServer (tried versions 6.0, 6.0.1, 6.0.23, 6.0.30, 6.0.31-RC6, 6.0.32)
Any ideas???
Thanks a lot in advance!
Jeeosch
For info: I posted the same issue in the Synology forums.