Page 1 of 1
Twonky server is multiplying itself
Posted: Thu Jun 10, 2010 8:24 pm
by Maynard
Hi
I'm using Twonky server 5.1.5 on ReadyNas Duo. The server is multiplying itself for some reason. Arter install i have .9000, but after a few days .9001 show up and then after that .9002 and so on. The problem was there also with 5.1.3. Anyone seen this before and possible solution?
Maynard
Re: Twonky server is multiplying itself
Posted: Fri Jun 17, 2011 8:13 pm
by darren_h
Hi,
Yes I am getting this - all the more frustrating as I have Squeezebox running on port 9002.
Can we force through a RPC call or something Twonky to run on 9001 so ideally I can run Squeezebox on 9000?
This would be good. I have Twonky 6.0.32.
I've uninstalled Twonky until I know a solution...
Re: Twonky server is multiplying itself
Posted: Sat Jun 18, 2011 12:09 am
by Twonky_Rick
Here is some info which may be useful. I've tried this on the PC, but I'm not sure if this works on all NAS.
- If you leave the “httpport†setting blank it will default to port 9000
- If port 9000 is taken, the server will automatically scan for the next free port
- You can override the default HTTP port setting with your own setting. Typical values are in the range of 8000 to 9999
- After TwonkyServer is installed, it no longer reads the default INI file -- except when the user selects a ‘reset to defaults’ command.
- Normally the server will use the twonkymedia-server.ini file, which is stored under the Applications/user folder. This is the same location where the server database is stored.
- Make sure to put the change in the twonkymedia-server.ini file (and not the twonkymedia-server-default.ini file)
- Make sure to restart TwonkyServer after making a change in the .ini file
- If TwonkyServer server is running you can also try this from your browser:
http://127.0.0.1:9000/rpc/setoption?httpport=9200
Rick