Hi guys,
I have just bought the LaCie EDmin 500GB and updated tot firmware 1.1.1. My Xbox360 doesn't see the Twonky Media upnp server?! Even XBMC doesn't see it. I know it runs fine, because when I use XP it sees the upnp server. Do I have to set specific setting to my router?
Thankx
Alexander
LaCie EDmin 500GB
...make sure UPnP, is turned on in ur router.
Here's what worked for me, as i had a simular problem
1. turn off ur Xbox and lacie drive
2. turn on the lacie drive, give a few minutes, maybe even 5...
3. turn on the xbox...give it a few & then go into ur media tab...it should work then,,,or at least it does for me when i run into the same issue...
Good luck!
Here's what worked for me, as i had a simular problem
1. turn off ur Xbox and lacie drive
2. turn on the lacie drive, give a few minutes, maybe even 5...
3. turn on the xbox...give it a few & then go into ur media tab...it should work then,,,or at least it does for me when i run into the same issue...
Good luck!
I did a bit testing last night. If I restart the LaCie EDmini and leave the Xbox360 searching it sees the UPnP AV. It cannot connect. If I search again it doesn't find anything. A few things I tried:
- Check UPnP is activated on the Linksys WAG-200
- Turn off te firewall on the Linksys WAG-200
- Set NAT entries for the Twonky Media server on the Linksys WAG-200
This seems to be network issue. In particular a router issue. The strange thing is that XBMC has the same issue.
Setup:
Router Linksys WAG-200
Wireless Game Adapter: WGA-54G
AV Control Center: Joytech 245C
Xbox360
Xbox - XBMC
- Check UPnP is activated on the Linksys WAG-200
- Turn off te firewall on the Linksys WAG-200
- Set NAT entries for the Twonky Media server on the Linksys WAG-200
This seems to be network issue. In particular a router issue. The strange thing is that XBMC has the same issue.
Setup:
Router Linksys WAG-200
Wireless Game Adapter: WGA-54G
AV Control Center: Joytech 245C
Xbox360
Xbox - XBMC