I am using the Twonky 8.5 (bought through QNAP) on a QNAP TS653A. The device has 4 network cards. After the installation, Twonky shows me in the overview that it runs on all 4 network cards. This is not desirable. Twonky should only run on the second network card. This does not seem to be possible via a Twonky configuration page. How can I set this up?
I would also like to
- only make the configuration page accessible for one system (password protection on HTTP is not optimal). What are the options?
- convert the configuration page from HTTP to HTTPS. is this possible?
Thank you very much. best regards
Other OS or NAS discussions
1 post • Page 1 of 1