Twonky Forum

I upgraded the firmware on my Linkstation Live to 2.10. After the upgrade twonky stopped working (which didn't really surprise me). I tried installing the latest version (4.4.3.1). Although the install went okay and ps shows that twonkymedia and twonkymediaserver are running I can't access the config pages via web access.

The media server is apparently running but isn't sharing anything.

I tried down-reving to 4.4.2 (which had been previously working). It took some work since the installer expected files to be in /mnt/disk1/twonky but didn't seem to move them there. Anyway, it runs but fails to respond to web access as well.

Any suggestions?

Thanks,

Marc

Found it! I hadn't used the setup page in a while. I used the port # (9000) that the nassetup window listed. The twonky server is really sitting on port 9010.

Hey,

Thanks! I was also looking for port 9000.