hello,
i am using the linux twonky server on a computer with 3 network adapters. (each adapters has its own subnet)
if i use the default config, the twonky server is reachable on all adapters including localhost and the wan ip adress.
how could i configure the server that only two chosen adapters will work?
the config file twonkymedia-server.ini allows only one ip. any idea?
greetings
fluxx
multiple network adapters
Re: multiple network adapters
I doubt that you can do what you want. The Network config page says "If an IP address is specified the server will not automatically bind to all network interfaces, but just to the specified ones." so it looks like you can bind to one or all interfaces.
Can you just block access to the clients on the interface you don't want connected?
PB
Can you just block access to the clients on the interface you don't want connected?
PB
- DaemonBeetle
- Posts:305
- Joined:Mon Dec 28, 2009 11:05 am
- AV Hardware:Plex Media Server, Samsung Smart TV (2009 and 2013)
Re: multiple network adapters
However, that uses plural, not singular, so you can probably specify multiple addresses. It is simply a question of what the separator is - spaces, commas or what.
Re: multiple network adapters
yes, i thought so too. but what is the right separator?
i tried several serparators but no one works properly.
with spaces the server-status shows two ip addresses in a row
but only the first is reachable.
i tried several serparators but no one works properly.
with spaces the server-status shows two ip addresses in a row
but only the first is reachable.